Example sentences of "[is] set too " in BNC.
Next page| No | Sentence |
|---|---|
| 1 | If the level of this is set too high , there may be an adjuster which controls it , or you may be able to simply bend the float arm down to the correct level . |
| 2 | If the phase resistance is set too high the a.c. current component is low and the power losses ( r ) are small . |
| 3 | If the constant clock frequency is set too high the motor is unable to accelerate the load inertia to the corresponding stepping rate and the system either fails to operate at all or loses steps at the start of its travel . |
| 4 | If it is set too low , then Offline will accomplish its workload using less ‘ portions ’ ie. it will calculate how many blocks can be stored and then continue until it has achieved that workload regardless of the 15 minute factor . |
| 5 | If it is set too high then the end of tape may be physically reached and Offline will believe there is still space available . |
| 6 | If it is set too low , then the opposite occurs and Offline will believe the tape is full when there may be more space available . |